Martin ERA 300 Profile user guide
17
Setting values
Go to the MANUAL CONTROL menu and press ENTER. Use the UP and DOWN buttons to select
the function you wish to control.
You can select Strobe, Dimmer, Dimmer Fine, Cyan, Magenta, Yellow, Color, Gobo1, RGobo1,
Gobo2, Prism, R-Prism, Iris, Zoom, Focus, Pan, Pan Fine, Tilt, Tilt Fine, Pan/Tilt Speed and
Function.
Once you have selected a function, press ENTER, then use the UP and DOWN buttons to select a
value from 0 to 255.
Press MENU to go back up and select a different function to control.
Pan/tilt correction when knocked
Normally if the fixture is knocked or pushed while set to a position it will automatically return to the
correct position. You can turn this feature off.
Go to the SERVICE menu and press ENTER.
Select P/T FEEDBACK and press ENTER.
Use the UP and DOWN buttons to select NO (sensors enabled, unit will correct) or YES (sensors
disabled, unit will not correct).
Press ENTER to store the setting.
Calibration
Martin® fixtures are adjusted and calibrated at the factory, and further calibration will normally only
be necessary if fixtures have been subjected to abnormal shocks during transport, if normal wear
and tear has affected alignment after an extended period of use. You can also use calibration to
fine-tune fixtures for a particular location or application.
The Calibration menu lets you define offsets in the fixture software to adjust the positions of pan,
tilt etc. relative to the DMX values the fixture receives. This allows you to fine-tune fixtures and
achieve uniform behavior in different fixture.
Loading and storing default calibration offsets
Go the SERVICE menu and press ENTER
Select CALIBRATION and press ENTER
Use UP and DOWN button to select function that requires calibration and press ENTER
Adjust value to desired level and press ENTER
Note
LOAD DEFAULTS lets you erase the calibration offsets that you have defined and reload the
default calibration offsets that are stored in memory.
SAVE DEFAULTS lets you overwrite the factory default calibration offsets that are stored in
memory with any new offsets that you have defined. Overwriting is permanent, so once you have
saved new default offsets, LOAD DEFAULTS will now load the new defaults, not the original
factory defaults.
Summary of Contents for ERA 300 Profile
Page 1: ...ERA 300 Profile User Guide...