Martin ERA 300 Profile user guide
5
codes and has both overload and ground-fault (earth-fault) protection.
Isolate the fixture from power immediately if any seal, cover, cable, or other
component is damaged, defective, deformed or showing signs of overheating.
Do not reapply power until repairs have been completed.
Before using the fixture, check that all power distribution equipment and cables
are in perfect condition and are of suitable type for the location (including water,
pollution, temperature and UV resistance).
Do not immerse the fixture in water or any other fluid, or install it in a location
where flooding may occur.
Protection from burns and fire
Do not operate the fixture if the ambient temperature (Ta) exceeds 40° C (104°
F).
The surface of the fixture can reach up to 70° C (158° F) if the fixture is
operated at the maximum permitted ambient temperature. Allow the fixture to
cool for at least 40 minutes before handling.
Install the fixture on a non-combustible surface (brick, concrete, plaster etc.)
only.
Do not aim the fixture towards combustible materials (fabric, wood, paper etc.)
that are within 20 cm (4 in.)
of the fixture.
Keep the fixture well away from flammable materials (volatile liquids etc.). Keep
all combustible materials (e.g. fabric, wood, paper) at least 200 mm (8 in.) away
from the fixture head.
Ensure that there is free and unobstructed airflow around the fixture. Provide a
minimum clearance of 200 mm (8 in.) around fans and air vents.
Do not illuminate surfaces within 500 mm (19.7 ins.) of the fixture.
Do not attempt to bypass thermostatic switches or fuses.
Do not modify the fixture in any way not described in this manual or install other
than genuine Martin® parts. Do not stick filters, masks or other materials onto
any lens or other optical component.
Protection from eye injury
Warning! Risk Group 3 (high risk) product according to EN 62471 and IEC/TR
62778.
Do not look directly into the product’s light output.
Do not look at operating lamp. Eye injury may result.
Do not expose persons to the product’s light output from a distance of less than
1.6 m (5.2 ft.).
Do not look at the light output with magnifiers, telescopes, binoculars or similar
optical instruments that may concentrate the light output.
Ensure that persons are not looking directly into the front of the fixture when the
product lights up suddenly. This can happen when power is applied, when the
product receives a DMX signal, or when certain control menu items are
selected.
To minimize the risk of eye irritation or injury, disconnect the fixture from power
at all times when the fixture is not in use and provide well-lit conditions to reduce
the pupil diameter of anyone working on or near the fixture.
The ERA 300 fixture fixtures fall into the following risk groups according to EN
62471 and IEC/TR 62778 at the distances indicated below.
Summary of Contents for ERA 300 Profile
Page 1: ...ERA 300 Profile User Guide...