7. When installing new tubes, line them up so that the manufacturer’s
markings on all tubes are at the same end of the luminaire. Tube
positions are labelled
R
for red,
G
for green and
B
for blue. Slide
each tube’s terminal pins fully into their sockets and rotate the tube
approx. 1/4 turn in either direction to engage the pins. Check that
tubes are held securely.
8. Reinstall the diffuser, reflector, white tube (in 04 models) and front
cover before reapplying power.
Tube positions
The burning positions of fluorescent tubes affect their warm-up times,
operating temperature, light output and tube life. For optimum results:
• Install tubes so that the manufacturer’s markings are all at the same
end of the luminaire.
• If the luminaire is installed in a vertical position or at an angle from the
horizontal, locate the ends of the tubes that carry the manufacturer’s
markings at the lower end of the luminaire. However, in a cold
environment, i.e. where temperatures are generally around or below
freezing point, locate the markings at the
upper
end of the luminaire).
www.carlosmendoza.com.mx
Summary of Contents for Cyclo Directional IP65
Page 1: ...user manual Cyclo Directional IP65...
Page 47: ......