Martin Cyclo Directional IP65, User Manual

Page: 17 / 48

Installation 17
2. See Figure 10. Dismantle the cable gland.
3. Ensure that there is a rubber O-ring A on the housing end of the cable
entry B , and screw this end into the threaded hole in the housing. Tighten
until the O-ring A makes a water-resistant seal against the outer surface
of the housing. Do not over-tighten, as this may damage the seal or
housing.
4. Thread the cable through the compression nut E , washer D , gland C , and
cable entry B into the housing.
5. Allow approx. 20 cm (8 in.) of cable slack inside the housing. Prevent the
cable entry from turning and tighten the compression nut sufficiently to
make a water-resistant seal. Do not over-tighten, as this may damage the
gland. Check that the cable is firmly gripped in the rubber gland.
Figure 10
: Metal cable gland
A
B
C
D
E
A – O-ring seal
B – Cable entry
C – Gland
D – Washer
E – Compression nut
www.carlosmendoza.com.mx