Martin Cyclo Directional IP65, User Manual

Page: 11 / 48

Installation 11
Mounting
DANGER! It is the installer’s responsibility to ensure that the
installation is safe and that all local safety regulations and legal
requirements are observed when mounting the Cyclo IP65 Directional.
The Cyclo IP65 Directional can be surface-mounted on a floor, wall or
ceiling. To surface-mount the Cyclo IP65 Directional:
1. Ensure that the mounting surface is flat and can support the weight of all
the devices to be installed on it. Allow 25 mm (1 inch) of free space
around each luminaire.
2. Using the mounting bracket as a guide, mark up and drill holes in the
mounting surface to take mounting fasteners.
3. Fasten the mounting bracket to the surface with at least two fasteners
that have sufficient corrosion resistance and strength to mount the
luminaire safely. Choice of mounting hardware will depend on the
installation, but use high-quality corrosion-resistant fasteners with
recommended minimum properties grade A4-70 (ISO 3506), or grade 8.8
(ISO 898-1). Any nuts used must be self-locking.
4. Check that the bracket is not distorted and is securely attached to the
mounting surface.
5. See Figure 4. To install the luminaire on the mounting bracket, hook the
raised T-section (A) on the lower side of the luminaire base into the
channel (B) on the mounting bracket, then swing the luminaire up so that
1
A B
5mm
2
C E D
Figure 4: Installing on the mounting bracket
www.carlosmendoza.com.mx