34
Cyclo IP65 Directional user manual
Example 4
DIP switch 7 is set to OFF (blackout fading) and red and blue are activated:
Example 5
To achieve a rainbow effect, activate red, green and blue tubes and set DIP
switch pin 7 to ON (crossfading).
Activating master/slave stand-alone operation
To activate master/slave stand-alone operation:
1. Isolate all luminaires from power.
2. Set all luminaires as slaves and enable stand-alone mode by setting DIP
switch pins 9 and 10 to ON and pin 8 to OFF.
3. Decide which luminaire to use as master and set this luminaire’s DIP
switch pin 9 to OFF. Note that any luminaire can be set as master, but
you will obtain the most reliable data signal by either setting the first
luminaire on the link as master or using 120 Ohm resistors to terminate
the data link (see “
both
ends.
4. When power is applied, slave luminaires will go to the next scene in their
program each time the master goes to its next scene. Slave luminaires
will also start scene 1 of their programs each time the master starts
scene 1 of its program.
2
1
4
3
4
2
1
3
4
2
1
3
Red
Blue
Scene
1
2
3
1
2
3
1
2
3
1
2
3
Red
Green
Blue
Scene
www.carlosmendoza.com.mx
Summary of Contents for Cyclo Directional IP65
Page 1: ...user manual Cyclo Directional IP65...
Page 47: ......