Martin Cyclo Directional IP65, User Manual

Page: 23 / 48

Installation 23
Configuring luminaires for DMX or stand-alone
operation
Each DMX model Cyclo IP65 Directional luminaire needs to be set up for
DMX or stand-alone operation using the DIP switch located on the circuit
board in the base module.
C o n f i g u r i n g f o r D M X o p e r a t i o n
DMX operation is enabled by setting pin 10 on the DIP switch to OFF. Pins
1 - 9 are then used to set the luminaire’s control address.
The Cyclo IP65 Directional uses one DMX channel to control each tube.
The DMX address, also known as the start channel, is the first of these
channels. It must be set on the luminaire (and selected on the DMX
controller) before the controller can send commands to the luminaire via a
data link. For example, a Cyclo 04 IP65 Directional with its DMX address set
to 101 uses channels 101, 102, 103 and 104 to control its four tubes.
Allow enough channels when setting the DMX address. If control channels
for two luminaires overlap, one of the luminaires will receive the wrong
commands.
If two or more Cyclo IP65 Directional luminaires share the same DMX
address, they will receive the same commands and respond identically.
Individual control will be impossible.
The default factory-set control address is ‘1’.
To set the Cyclo IP65 Directional’s DMX address:
1. Set DIP switch pin 10 to OFF.
1 2 3 4 5 6 7 8 910
ON
Figure 12: DIP switch
www.carlosmendoza.com.mx