Martin Cyclo Directional IP65, User Manual

Page: 29 / 48

Stand-alone operation 29
Stand-alone operation
DANGER! Read “ Safety information ” on page 3 before attempting to
operate this product!
In stand-alone operation, the Cyclo IP65 Directional can run light shows
without a DMX controller. Luminaires can be programmed to change colors
in cycles. Changes can be programmed at 1, 5, 10 or 30 second intervals.
Two stand-alone operation modes are available:
• In single stand-alone operation , luminaires run independently of each
other. No data link is required.
• In master/slave stand-alone operation , luminaires must be linked with a
serial data link (“ Linking luminaires for DMX and synchronized operation ”
on page 21 explains how to install this link). Synchronized action in all
luminaires is triggered by one “master” luminaire.
In both single and master/slave stand-alone operation, luminaires are
programmed by setting the pins on the DIP switch on the circuit board as
shown in the following table.
Pin Function
1 White active (04 models), red active (03 models)
2 Red active (04 models), green active (03 models
3 Green active (04 models), blue active (03 models)
4 Blue active (04 models)
5 & 6 Program speed
Pin 6 Pin 5 Speed
OFF OFF 1 sec. steps (fastest setting)
OFF ON 5 sec. steps
ON OFF 10 sec. steps
ON ON 30 sec. steps (slowest setting)
7 OFF = Blackout fading, ON = Crossfading
8 OFF = Run program, ON = Deactivate program (Note: always set to OFF)
9 OFF = Master, ON = Slave (Note: do not set more than one luminaire as master)
10 ON = Stand-alone mode.
Table 3. Stand-alone DIP switch settings
www.carlosmendoza.com.mx