16
Cyclo 03 Directional user manual
Setting a static color display
In stand-alone operation, a static (non-changing) color display can be set by
pausing the program at the point where it is showing the desired color.
Either one color or a mix of two colors can be “frozen” in this way.
To set a static color display:
1. Activate the color you wish to display (if you wish to display a two-color
mix, activate these two colors) on DIP switch pins 1 to 3.
2. Set the luminaire as master by setting DIP switch pin 9 to OFF.
3. Set DIP switch pins 5 and 6 to ON to activate the slowest program speed.
4. Set DIP switch pin 7 to OFF to activate crossfading and DIP switch pin 8
to OFF to activate the program.
5. When the desired color or color mix appears, pause the program by
moving DIP switch 8 to ON. This color will remain “frozen” until DIP
switch 8 is moved to OFF.
Note that the paused color is lost when the luminaire is powered off. When
powering the luminaire on again, DIP switch pin 8 must be moved to OFF
before the program will start.
Single stand-alone operation
In single stand-alone operation, a luminaire runs its own program
independently of all other luminaires. To do this, the luminaire must be set
as a master.
Activating single stand-alone operation
To activate single stand-alone operation:
1. Set DIP switch pin 10 to ON (activates stand-alone mode).
2. Set DIP switch pin 9 to OFF (activates master mode).
3. Apply power and program the luminaire using DIP switch pins 1 - 8 (see
"Table 1. Stand-alone DIP switch settings
" on page 14).
Master/slave stand-alone operation
Important! Do not set more than one luminaire on a data link as master,
and do not set a luminaire as master on a data link with a DMX
Summary of Contents for Cyclo 03 Directional
