Martin Cyclo 03 Directional, User Manual

Page: 14 / 36

14 Cyclo 03 Directional user manual
Stand-alone operation
In stand-alone operation, the Cyclo 03 Directional can be used without a
DMX controller. Static single colors or two-color mixes can be displayed, or
luminaires can be programmed to change colors in cycles. Changes can be
programmed at 1, 5, 10 or 30 second intervals.
Two stand-alone operation modes are available:
• In single stand-alone operation , luminaires run independently of each
other. No data link is required.
• In master/slave stand-alone operation , luminaires must be linked.
Synchronized action in all luminaires is triggered by one “master”
luminaire.
In both single and master/slave stand-alone operation, luminaires are
programmed via the pins on the DIP switch on the luminaire’s housing as
shown in Table 1.
Pin Function
1 Red active
2 Green active
3 Blue active
4 Not used
5 & 6 Program speed
Pin 6 Pin 5 Speed
OFF OFF 1 sec. steps (fastest setting)
OFF ON 5 sec. steps
ON OFF 10 sec. steps
ON ON 30 sec. steps (slowest setting)
7 OFF = Blackout fading, ON = Crossfading
8 OFF = Run program, ON = Pause program
9 OFF = Master, ON = Slave (Note: do not set more than one luminaire as master)
10 ON = Stand-alone mode.
Table 1. Stand-alone DIP switch settings