Martin Cyclo 03 Directional, User Manual

Page: 18 / 36

18 Cyclo 03 Directional user manual
When crossfading is selected, each color takes up one scene (fade in only).
When blackout fading is selected, each color takes up two scenes (fade in
and fade out). This means that a maximum of 6 scenes can be programmed
with all 3 colors activated and blackout fading selected.
Each time the master luminaire starts at scene 1, it sends a signal to all the
slave luminaires to start at scene 1. This means that if a slave luminaire has:
1. Fewer scenes than the master luminaire, it will run these in a cycle until
the master luminaire signals that the program should start from the
beginning again.
2. More scenes than the master, the additional scenes will never run,
because the program will reset to the first scene when the master starts
its program from the beginning.
Here is an example of what will happen when a slave luminaire has fewer
scenes than the master luminaire:
Program examples
The following examples show how an individual luminaire’s program is
made up of scenes.
The following symbols are used in program diagrams:
Example 1
DIP switch 7 is set to ON (crossfading) and only red is activated:
Luminaire setting Scene pattern
Master with 6 scenes 1 2 3 4 5 6 1 2 3 4 5 6 1 2 3 4 5 6 . . .
Slave with 4 scenes 1 2 3 4 1 2 1 2 3 4 1 2 1 2 3 4 1 2 . . .
Tube turned fully off
Fade in
Fade out
Fade to 50% and back to 100% in one scene
(applies when only one color is active and
crossfading is selected)
1 1 1 1 1 1 1 1 1 1 1 1
Red
Scene