Maretron DSM150, User Manual

Page: 211 / 274

Revision 1.4.18 Page 195
the network must have a different value). Where the value 255 appears in the subnet mask, the
values define the network and must be the same.
The most common value is 255.255.255.0.
If the “DHCP” parameter is set to “Yes”, you do not need to configure this parameter. If the “DHCP”
parameter is set to “No”, you will need to configure this parameter.
6.30.7 Default Gateway
This is the IP address of the router.
If the “DHCP” parameter is set to “Yes”, you do not need to
configure this parameter. If the “DHCP” parameter is set to “No”, you will need to configure this
parameter.
6.30.8 Default DNS
This is the IP address of a computer on the Internet that can identify and locate computer systems
and resources on the internet. In most cases, this should not be required by the VDR100 and may be
left blank.
If the “DHCP” parameter is set to “No”, you will need to configure this parameter.
6.31 Maretron WSO100 Configuration
The DSM150 is capable of performing configuration of the WSO100 Wind/Weather Sensor. This
describes the configuration of the Maretron WSO100 firmware version 2.0.13. Figure 223 below
shows a screenshot of the WSO100 configuration menu.
Figure 223
– WSO100 Configuration Screen
6.31.1