User Manual - Sigillo
®
- 37
Cable fastening:
Now that the steel cable has been properly positioned on its path, the cable fastening activities can be carried out.
WARNING!
During installation of the metal cable, it is strictly mandatory to wear gloves in order to prevent hand
injuring caused by the possible fraying of the metal mesh.
Note:
Before fastening the cable, check carefully wheter the covering is equipped with a single or double pulling bow.
COVERING WITH SINGLE OR DOUBLE PULLING BOW (STANDARD CABLE)
1. Take the cable which comes back from the rear part (pulley side)
(5)
and pass it at the outside of the pulling bow support
(3)
.
2. Tighten the steel cable by pulling it manually.
3. Fasten both ends of the cable
(1)
&
(5)
pulling them through the specific supplied clamps
(2)
&
(4)
.
COVERING WITH DOUBLE PULLING BOW (LOWERED CABLE)
1. Insert a clamp
(3)
in the inner side of the support
plate of the double pulling bow
(4)
.
2. Take the end of the cable
(1)
which comes back
from the vehicle cab side and fasten it with the
clamp
(3)
.
3. Take the end of the cable which comes back
from the rear side of the vehicle (pulley side)
(7)
,
overlap the first one
(1)
passing it through the
inner side of the support plate
(4)
.
4. Fasten both ends with a clamp
(5)
inserted in the
inner side of the plate
(4)
. Before tighten the
clamp
(5)
, pull the cable manually for tensioning
it.
5. Loose the first fastened clamp
(3)
and refasten it
holding both cables.
6. For greater safety, it is mandatory to fasten one
additional clamp on the left
(2)
and right
(6)
of the
previously fastened ones.
CAB SIDE
PULLEY SIDE
PULLEY SIDE
CAB SIDE
CAB SIDE
PULLEY SIDE
