22 - User Manual - Sigillo
®
3.2.4 Description of the radio remote control
The radio remote control consists of a pocket remote control to be used also as a key fob.
Below the available switches:
1.
UNCOVERED
switch (to uncover the tipper body)
2.
COVERED
switch (to cover the tipper body)
ORDINANCE!
The remote control
MUST BE KEPT AND USED EXCLUSIVELY by the operator.
After each use, the remote control must be stored in a not accessible place.
Before using the pocket remote control, the operator must verify the absence of any
unauthorised personnel close to the Motor Control Unit.
WARNING!
It is absolutely forbidden to use the remote control when the vehicle is moving.
The constructor declines any responsibility.
3.2.5 Unfolding the Sigillo
®
covering for covering the tipper body
In the starting position of the system, the tarpaulin is folded on the front part of the tipper body. To unfold it, operate as
follows:
1. Check that the upper edges of the tipper body are free from any obstacle.
2. Remove all elastic strings (if provided for the version installed on your vehicle) from the front hooks so that the covering
can move freely.
3. Insert the key in the emergency pushbutton.
4. Turn the key in CLOCKWISE direction to unlock the emergency pushbutton for giving the consent to start the machine:
When the Motor Control Unit is activated, it gives off an acoustic signal.
On remote control
: PRESS THE PUSHBUTTON no. 2 (
COVERED
)
On Motor Control Unit
: ROTATE THE CONTROL DIAL no. 3 TOWARDS RIGHT (
COVERED
)
5. Unfold the tarpaulin completely and release the control dial. The Motor Control Unit is equipped with an automatic motor
shut-down system when covering reaches the end stop.
6. Close the covering on the rear side (in case of automatic rear closing system this operation takes place automatically).
7. Hook the elastic strings into the lateral hooking points to fasten the tarpaulin for the transport way (if provided for the
version installed on the vehicle).
8. Press the emergency mushroom pushbutton and remove the key.
9. Carry out a quick but attentive control, especially of the automatic hooks, to verify that everything is in good order before
moving the vehicle on the road.
3.2.6 Interruption of machine operations
For stopping the covering moving, release simply the control dial on the Motor Control Unit or the pushbutton on the remote
control.
