38 - User Manual - Sigillo
®
WARNING!
IT IS FORBIDDEN TO use different materials than those supplied with the system.
The cables must be secured with 4 galvanized steel clamps for Ø 6 cable, placed as shown in the
figures above (i.e., 2 on each side).
WARNING!
An incorrect fastening of clamps, the lack of one or more clamps as well as a different fastening process
from the described one can compromise the tarpaulin stability on the tipper body, causing its
detachment with danger and damages to people and objects.
IT IS FORBIDDEN TO use different materials than those supplied with the covering system to
avoid invalidation of warranty.
•
After having fastened the steel cable, cut the excess lenght off, but leave about 100-150 mm usable for any necessary
adjustments.
Note:
Prior to cutting the cable, wrap the cut surface with insulating tape to prevent a possible fraying.
Positioning the right steel cable:
Even in this case, it is important to begin by the frontal part of the body, passing the cable through the driving system:
1. Insert the two ends of the cable from the external part towards the inside of the gear housing; while inserting the steel
cable, make sure that the lower end of the cable (which will become the upper end after crossing), is sufficiently long to
reach the pulling bow.
2. Wrap the steel cable around the main pulley (1) making its two ends pass over and under,
in correspondence with the
innermost groove
.
3. Insert the two ends of the steel cable into the gear housing.
4. Insert the lower end into the outer upper pulley (2).
5. Insert the upper end onto the outer lower pulley (3).
