Installation manual - Eletta
®
- 37
C
C
h
h
a
a
p
p
t
t
e
e
r
r
4
4
A
CCESSORY EQUIPMENT INSTALLATION
4.1 Automatic rear closing system
Note:
The automatic rear closing system can be provided only together with the double pulling bow.
The covering system is available with an innovative rear
closing system which avoids that the operator has to
position by hand the end part of the tarpaulin when
securing the tipper body.
This system requires a close attention during the fastening
operation of the tarpaulin on the front side of the tipper
body.
Here below the operations to perform:
•
Unfold the covering (by hand or electrically, depending on
the installed covering version) and cover the tipper body
stopping the pulling bow at a distance from the tailgate
that corresponds to the length of the closing system when
completely closed.
•
Tighten up and fasten the PE flat strip (
3
) on the superoir
lateral casing.
•
Tighten up the front part of the tarpaulin.
•
Fasten the tarpaulin and the PE flat strip (
3
) on the top of
the tipper body, using the specific clamping plate (
2
) and
rivets (
1
).
•
Cut the excess tarpaulin part off.
Now it is possible to set up the automatic rear closing system in order that while closing the tarpaulin manually or electrically,
arriving at the end stop, the rear closure comes down automatically.
WARNING!
For carrying out certain maintenance work the access to the internal space of the tipper body
is required. Make sure that the internal space is empty and clean to avoid any sliding and
falling. Wear suitable protective clothing.
ALL MAINTENANCE WORK MUST BE PERFORMED BY STATIONARY VEHICLE AND
DISCONNECTED EQUIPMENTS
DO NOT WALK ON THE TARPAULIN!
Marcolin Covering s.r.l. denies any liability.
•
Move out the tarpaulin (manually or electrically depending on the version) and cover the tipper body (fig. 1).
fig. 1
fig. 2
