March Networks GW-DS150N, Manual

Page: 40 / 65

42
‘Information’ button to see the detailed information about selected access point.
Start PBC pairing procedure at access point side (please refer to the instruction given by your access
point’s manufacturer), then click ‘PBC’ button in wireless configuration utility to start to establish wireless
connection by WPS. Please be patient (This may require several seconds to one minute to complete).
When you see 'WPS status is connected successfully’ message, means the connection between this
wireless network card and access point is successfully established by WPS, and the information about
access point you connected to will be displayed.
You can click ‘Detail’ button to see detailed information of connected access point. If you wish to save this
connection as a profile, you can click 'Export Profile’ button, and this connection will be saved. You can
find this connection in ‘Profile’ tab in a later time.
Sometime WPS may fail (In the following picture, WPS pairing is failed because no WPS-enabled
access point is found):
You can click ‘PBC’ button few more times to try again. When an access point is connected, you can click
'Disconnect' to disconnect your wireless network card from a connected access point, or select another
WPS-enabled wireless access point, then