Marani LPP-480F, User Manual

Page: 30 / 64

the User can only change the USER Password. To change the password the User must:
1. Input the current USER Password on the text-box below the label “User Password” (6
characters)
2. Input the wanted USER Password on the text-box below the label “New User Password” (6
characters)
3. use the apply button to confirm it.
the “USER MODE LOCKED FUNCTIONS” parameters can be modify only in ADMIN Mode
- when set the “Program Store Lock” then the User can't store program to device
- when set the “Factory Recall Program Lock” then the User can't use the button
- when set the “Output Limiter Lock” then the User can't edit all output Peak Limiter parameters
- when set the “Output Compressor Lock” then the User can't edit all output RMS Compressor
parameters
- when set the “Output X-Over Lock” then the User can't edit all output HP/LP IIR/FIR filter
parameters
- when set the “Output Delay Lock” then the User can't edit all output Delay parameters
- when set the “Output Gain/Phase Lock” then the User can't edit all output Gain and Phase
- when set the “Output Routing Lock” then the User can't edit all output Routing (CH.Y ->
OUT-Y)
- when set the “FIR Lock” then the User can't edit all FIR (Block)
−
ADMIN SETTINGS
this pages is visible only in ADMIN Mode.
The Admin can change the “Adim password”. To change the password the Admin must:
1. Input the current ADMIN Password on the text-box below the label “Admin Password” (6
characters)
2. Input the wanted ADMIN Password on the text-box below the label “New Admin Password”
(6 characters)