Manusa VECTOR, Installation Manual

Page: 41 / 48

40
D00619EN - v0 SWING OPERATOR - INSTALLATION MANUAL
7.4 Risk Assessment
MECHANICAL HAZARDS
Risk Dangerous
Area Risk Prevention Measures
Structural Machine area Assess the suitability of the structure where the machine is going to be installed:
a levelled floor with sufficient load capacity, no obstacles in the transit area,
firm ground free of irregularities, etc.
Stability Machine area Attach the different machine parts in a stable way, using appropriate materials and strictly
adhering to the indications in this manual
Shearing, Cut or
Severing
Closing area
•
Do not use float glass to manufacture/repair the leaves of the machine.
•
Check that there are no burred or sharp edges on any of the different door parts.
Dragging and
entrapment Inside the
operator Do not manipulate the interior of the operator while it is in operation.
Impact and
crushing Closing area •
Adjust the closing force of the machine to a value appropriate for its operation.
•
Verify the correct operation of the safety photocell barriers.
Crushing Machine area Exercise great caution when placing the leaf in its final location.
ELECTRICAL HAZARDS
Hazard Dangerous
Area Risk Prevention Measures
Direct or indirect
contact Inside the
operator •
Use components and electrical materials with CE marking.
•
Connect the electrical connections, the mains connection, the earth connection and verify
all connections following the indications in the wiring and connections manual.
•
Ensure the continuity of the conductors by using cables with sharp edges.
•
Perform all maintenance and adjustment tasks by strictly adhering to the specifications in
this manual.
Electrical energy
dispersal Operator •
Follow the technical instructions applicable under the low - voltage electrotechnical
regulations.
•
Connect the electrical connections, the mains connection, the earth connection and verify
all connections following the indications in the wiring and connections manual.
Electromagnetic
compatibility
hazards
Operator
•
Use components and electrical materials with CE marking.
•
Connect the electrical connections, the mains connection, the earth connection and verify
all connections following the indications in the assembly manual.
HAZARDS RELATED TO CONTROL AND SAFETY DEVICES
Hazard Dangerous
Area Risk Prevention Measures
Opening controls Door area
•
If manual controls are installed, place them correctly, protected from possible unauthorised
or malicious use.
•
Check and install the photocells following the instructions in the assembly, connection and
wiring manuals.
Lack of power Door area •
Check that the door operates safely again after the power supply has been interrupted.
Confinement Door area •
Check that the panic break - out system works properly and ensure that the door opens after
power supply failure.
Below, there is an outline of the different hazardous situations that may arise with our machines after leaving the factory, either
during the installation process, commissioning, maintenance, adjustment or disassembly. There is also reference to the risk
minimisation measures that must be taken during the aforementioned phases of the machine’s life: