Manitou MSI 40 T S3 ST3B, Operator'S Manual

Page: 91 / 114

3-25
D8 – PARKING BRAKE LEVER MECHANISM
GREASE
- Remove the protective bellow 1.
- Clean and grease articulation axles 2 with grease (see: 3 - MAINTENANCE: LUBRICANTS
AND FUEL).
- Replace the protective bellow 1.
D7 – HYDRAULIC RETURN OIL FILTER CARTRIDGE
CHANGE
IMPORTANT
Thoroughly clean the outside of the filter and its surroundings before any intervention in order to prevent any risk of
polluting the hydraulic circuit.
Stop the I.C. engine and remove the pressure from the circuits by acting on the hydraulic
controls.
- Lift up the cab (see: 2 - DESCRIPTION: INSTRUMENTS AND CONTROLS).
- Remove the plug 1 and unscrew cover 2 by two or three thread turns.
- Wait a few moments while the oil flows into the tank.
- Remove the cover and slowly take out filter cartridge assembly 3.
- Place the assembly in a clean container and empty the bowl.
- Separate the housing 4 and the head 5 from the filter cartridge 6 with a twisting
motion.
- Refit the bowl and the top onto a new cartridge (see: 3 - MAINTENANCE: FILTER
ELEMENTS AND BELTS).
- Put back the assembly then retighten the cover 2.
- Put the cap 1 back.
D9 – FRONT AXLE DIFFERENTIAL OIL
DRAIN
Place the lift truck on level ground with the I.C. engine stopped and the d oil still warm.
IMPORTANT
Dispose of the drain oil in an ecological manner.
DRAINING THE OIL
- Place a container under the drain plugs 1 and unscrew them.
- Remove level plug 2 and filling plug 3 to ensure that the oil is drained properly.
- Refit and tighten the drain plugs 1 (tightening torque 34 N.m).
FILLING UP THE OIL
- Fill up with oil (see: 3 - MAINTENANCE: LUBRICANTS AND FUEL) through filler port 3.
- The level is correct when the oil level is flush with the edge of opening 2.
- Check for any possible leaks at the drain plugs.
- Refit and tighten level plug 2 (tightening torque 34 to 49 N.m) and filling plug 3
(tightening torque 34 to 49 N.m).
1
2
2
1
1 1
3
2
2
1
3
6
4
5
647177 (23/02/2017) MSI 40/50 T S3 ST3B