3 - 36
3 - 36
- Loosen high pressure connectors 3 (fig. G1/3) of all the injectors.
- Loosen high pressure connectors 3 (fig. G1/3) of all the injectors.
- Activate the starter until the diesel fuel flows out free of air at high pressure connectors
- Activate the starter until the diesel fuel flows out free of air at high pressure connectors
3 (fig. G1/3).
3 (fig. G1/3).
Do not engage the starter motor on a continual basis for more than 30 seconds and let it cool
Do not engage the starter motor on a continual basis for more than 30 seconds and let it cool
between unsuccessful attempts.
between unsuccessful attempts.
- Tighten the connection while the diesel fuel is flowing out (tightening torque 22 ft/lb).
- Tighten the connection while the diesel fuel is flowing out (tightening torque 22 ft/lb).
- Install the muffler 1 (fig. G1/1).
- Install the muffler 1 (fig. G1/1).
- The I.C. engine is then ready to be started up.
- The I.C. engine is then ready to be started up.
- Turn the I.C. engine over slowly for 5
- Turn the I.C. engine over slowly for 5 minutes immediately after bleeding the
minutes immediately after bleeding the fuel feed cir-
fuel feed cir-
cuit,
cuit, in order to ensure that the injection pump has been bled thoroughly
in order to ensure that the injection pump has been bled thoroughly..
NOTE
NOTE : If the I.C. en
: If the I.C. engine functions correctly for a short time then stops or functions
gine functions correctly for a short time then stops or functions irreg-
irreg-
ularly,
ularly, check for pos
check for possible leaks in th
sible leaks in the low pressure
e low pressure circuit. If in
circuit. If in doubt,
doubt, contact your
contact your
dealer.
dealer.
G1/3
G1/3
3
3
3
3
3
3
3
3
2
2
Do not engage the starter motor on a continual basis for more than 30 sec-
Do not engage the starter motor on a continual basis for more than 30 sec-
onds and let it cool between unsuccessful attempts.
onds and let it cool between unsuccessful attempts.
IMPORTANT
IMPORTANT
G2 - W
G2 - W
HEEL
HEEL
CHANGE
CHANGE
In the event of a
In the event of a
wheel being changed on the public highway, make sure of
wheel being changed on the public highway, make sure of
the following points
the following points
:
:
For this operation we advise you to use an approved hydraulic jack and safety support (con-
For this operation we advise you to use an approved hydraulic jack and safety support (con-
tact your dealer).
tact your dealer).
- Park the lift truck,
- Park the lift truck, if possible on even and h
if possible on even and hard ground.
ard ground.
- Put the warning lights on.
- Put the warning lights on.
- Immobilize the lift truck in both directions on the axle opposite to the wheel to be
- Immobilize the lift truck in both directions on the axle opposite to the wheel to be
changed.
changed.
- Unlock the nuts of the wheel to be changed.
- Unlock the nuts of the wheel to be changed.
- Place the jack under the flared axle tube,
- Place the jack under the flared axle tube, as near as possible to the wheel and adjust the
as near as possible to the wheel and adjust the
jack (fig. G2/1).
jack (fig. G2/1).
- Lift the wheel until
- Lift the wheel until it comes off the ground and put in place the
it comes off the ground and put in place the safety support under the
safety support under the
axle (fig. G2/2).
axle (fig. G2/2).
- Completely unscrew the wheel nuts and remove them.
- Completely unscrew the wheel nuts and remove them.
- Free the wheel by reciprocating movements and roll it to the side.
- Free the wheel by reciprocating movements and roll it to the side.
- Slip the new wheel on the wheel hub.
- Slip the new wheel on the wheel hub.
- Install the
- Install the nuts by
nuts by hand,
hand, if necessary grease the
if necessary grease them.
m.
R
th
f t
t
d l
th lift t
k
ith th j
k
R
th
f t
t
d l
th lift t
k
ith th j
k
G2/1
G2/1
G2/2
G2/2
In the event of a wheel
In the event of a wheel being changed on the public highway, make sure o
being changed on the public highway, make sure of
f
the following points
the following points
WARNING
WARNING
CONTENTS
CONTENTS
https://www.forkliftpdfmanuals.com/
Summary of Contents for MLA 628 -120 LSU 3-E2 Series
