Manitou MLA 628 -120 LSU 3-E2 Series, Operator'S Manual

Page: 114 / 130

3 - 34 3 - 34
FILLING THE LIQUID FILLING THE LIQUID
- Tighten the drain valve 2 (fig. F1/2) and drain plug 3 (fig. F1/3) (tightening torque 30 - Tighten the drain valve 2 (fig. F1/2) and drain plug 3 (fig. F1/3) (tightening torque 30
ft/lb). ft/lb).
- Slowly fill up the cooling circuit ( - Slowly fill up the cooling circuit (see : 3 - MAINTENANCE see : 3 - MAINTENANCE : LUBRICANTS AND F : LUBRICANTS AND FUEL) to half UEL) to half
way up the expansion pan 5 (fig. F1/4). way up the expansion pan 5 (fig. F1/4).
- Install filler cap 4 (fig. F1/4). - Install filler cap 4 (fig. F1/4).
- Run the I.C. engine at idle for a few minutes.
- Run the I.C. engine at idle for a few minutes.
- Check for any possible leaks.
- Check for any possible leaks.
- Check the level and refill if necessary.
- Check the level and refill if necessary.
The I.C. engine does not contain any corrosion resistor and must be filled during the whole year The I.C. engine does not contain any corrosion resistor and must be filled during the whole year
with a with a mixture mixture containing 2 containing 2 5 5 % of ethylene glycol-based antifreeze. % of ethylene glycol-based antifreeze.
F1/3 F1/3
2 2
4 4
5 5
3 3
To pervent corrosion the I.C. engine cooling system must be filled with a To pervent corrosion the I.C. engine cooling system must be filled with a
minimum mixtur
minimum mixture of 25 e of 25 % ethylene glycol-based % ethylene glycol-based antifreeze. antifreeze.
IMPORTANT IMPORTANT
CONTENTS CONTENTS
https://www.forkliftpdfmanuals.com/