MAGUIRE Weigh Scale Blender, Installation Operation & Maintenance

Page: 64 / 141

M A G U I R E P R O D U C T S , I N C .
64
W E I G H S C A L E B L E N D E R

RNC 00050 Allowable GRAM error within which NO correction is made.
NNC 00050
CNC 00010
ANC 00010
This is the acceptable error range for each component to prevent hunting. They adjust automatically over an
extended time period to match the flow characteristics of each material.
RRP 00010 PERCENT shortage error that will force a retry.
NRP 00010
CRP 00010
ARP 00010
RRD 00500 GRAM weight shortage error that will force a retry.
NRD 00500
CRD 00050
ARD 00050
Both RP and RD limits must be met before system will advance to the next component. Retries occur until both
conditions are met.
RLA 00020 Lag TIME before dumping ACTUALLY starts.
NLA 00020 (mechanical response time, interrupts)
CLA 00012
ALA 00012
These parameters state the lag time between when a device is signaled and when it actually begins to operate.
Change ONLY if you change to non-standard equipment.
PRC 00010
MAX. PERCENTAGE CHANGE - Maximum allowable PERCENT rate change per cycle.
This prevents excessive swings in flow rates by the software. Do not change.
STL 00122 DISPENSE SETTLE TIME before a weight reading is taken.
The time (interrupts) allowed for material to SETTLE in the weigh bin before a weight is taken. Lengthen only to
slow the next cycle start, thereby lowering the pile of material in the mix chamber, and, in some cases, improving
mixing.
LCL 00027 LOAD CELL limits, low slope, high slope, frequency, zero.
LCH 00039 DO NOT CHANGE except for different weight load cells.
LCF 00079 The above 4 parameters relate to the characteristics of the LOAD CELLS on your blender.
LCZ 00583 DO NOT CHANGE THEM.
SCR 00000
Special Customer Request function to be activated.
BCR 00000 For BAR CODE input equipped blenders.
The following parameters are all related to EXTRUSION CONTROL only.
XTP 05050 Extrusion Control - TRIP POINT for a Rate adjustment.
As batch timing errors accumulate, this number determines how large the accumulated error
must be to force an adjustment.
XCV 00000 Extrusion Control - Extruder speed Control Voltage.
XRC 00004 Extrusion Control - Extruder speed Rate of Change.
These two parameters control the voltage output to the extruder speed control, and its rate of change.
TCV 00000 Extrusion Control - Takeoff speed control voltage.
TRC 00004 Extrusion Control - Takeoff speed Rate of Change.
These two parameters control the voltage output to the downstream
takeoff speed control, and its rate of change.
XAL 00005 Extrusion Control - Single Adjustment Limit, percent.
Single rate adjustments are limited to this percentage change.
XUL 00200 Extrusion Control - Upper Adjustment Limit, volts