MAGUIRE Weigh Scale Blender, Installation Operation & Maintenance

Page: 19 / 141

M A G U I R E P R O D U C T S , I N C .
19
W E I G H S C A L E B L E N D E R

5. Plug the CONTROLLER into the receptacle located under the controller tray.
IMPORTANT: Do NOT plug the controller into a separate power source.
The controller ground path MUST be the same as the blender frame
ground path. If your system has the controller located in a remote
location, MAKE CERTAIN that the power to the controller comes from
the receptacle mounted on the Blender frame.
6. Power Requirements:
WSB Model Voltage (60 hz) FLA Voltage (50 hz) FLA
MB 110/1/60 2.0 230/1/50 1.0
100/200/400 110/1/60 5.0 230/1/50 2.5
900/1200
110/1/60 (Controller) 4.0 400/3/50+N+PE 2.5
240/3/60 (Mix) 2.0
110/1/60 (Controller) 4.0
480/3/60 (Mix) 1.0
1800
110/1/60 (Controller) 4.0 400/3/50+N+PE 2.5
240/3/60 (Mix) 4.0
110/1/60 (Controller) 4.0
480/3/60 (Mix) 2.0
2400/3000
110/1/60 (Controller) 4.0 400/3/50+N+PE 4.0
240/3/60 (Mix) 3.2
110/1/60 (Controller) 4.0
480/3/60 (Mix) 1.6
Secure voltage supply cable per the requirements of EN 60204-1, Clause 13.4.2.
7. Connect Compressed Air to the unit. About 5.5 bar (80 psi) is recommended for
most models. 4.1 bar (60 psi) is recommended for: Micro Blender, 140R, 240R and
440R). Do not supply with lubricated air. Air provided to the blender should be clean
and dry. The coalescing filter is a final attempt to dry the air to protect the valves from
moisture contamination.
NOTE: Micro Blenders should be set to 4.1 bar (60 psi). The Vertical
Valves used in removable hoppers on Micro Blenders are more
accurate at the lower 4.1 bar (60 psi) pressure setting.
8. Upon completion of setup, an on-site safety inspection should be conducted to assess
for any additional safety hazards, before allowing the equipment to be handing off to the
machine operators.