MAGUIRE Weigh Scale Blender, Installation Operation & Maintenance

Page: 107 / 141

M A G U I R E P R O D U C T S , I N C .
107
W E I G H S C A L E B L E N D E R

Clear All
The " CLEAR ALL " routine sets
both current “
User Settings
” and “
User Backup Settings
” to the Blender's
model-specific default settings (the hard-coded values contained within the software itself). However, a
CLEAR ALL will preserve the most important user-defined settings, which are: model selection, stored
recipes, passwords and language configuration.
There are only TWO times when you want to do a CLEAR ALL.
1. When new software has been installed. Information may reside in memory locations that do not
match the new program. CLEAR ALL fixes this.
2. When all else fails. CLEAR ALL will sometimes fix problems that the simple CLEAR routine misses.
Restart with Default System Settings - the same as the CLEAR, above, but EEPROM information is also cleared.
Clear All - Keypad Sequence:
Switch Power Off to the Controller
Hold Hold these keys down simultaneously
Switch Power on to the Controller
Hold the VIEW, BTCH, EXIT keys until you see RESET on the display, then
Release
Release the keys
When done correctly, the display will say CLEAR ALL
If you do not see CLEAR ALL on the display, do it again.
LOAD CELL calibration WILL be lost. You will have to follow the Load Cell calibration procedure given in this manual.
Since parameter table information is lost, you will want to reenter parameters that were previously modified. See BRIEF
EXPLANATION of PARAMETERS for a quick review of which ones might have been changed.
Be certain that your unit displays the proper MODEL number when you turn on power. If not, see SELECTING CORRECT
MODEL.