Maguire Products GRAVIMETRIC AUGER FEEDER MGF-ST, Original Instruction Manual

Page: 9 / 50

M A G U I R E P R O D U C T S , I N C .
9
G R A V I M E T R I C A U G E R F E E D E R

MGF MENU Navigation - 5 Main Menu Options, 2 sub-menus
LBS/HOUR or SHOT WT – Setting Metering Rate or Shot Weight, grams. See page 10
LDR –
Let Down Rate, Percent. See page 10
SETUP –
Password protected access to options, settings and parameters See below ↓
FILL BIN –
Enabled if Loader Operation is ON. Manual fill of the bin (hopper)
PRIME FUNCTION –
Primes and calibrates the MGF See page 14
DIAGNOSTICS –
Displays information for troubleshooting purposes See page 35
SETUP – Password protected access to MGF Settings
(default: 2222) See page 18
SETTINGS – For changing basic setting of the MGF See below ↓
SCALE CALIBRATION –
For calibrating the MGF Scale See page 25
COMMUNICATIONS –
MLAN ID, View MAC Address, TCP/IP Address, TCP/IP Setup See page 26
LOADER OPERATIONS –
Loader On/Off, Loader on/off grams, Loader Alarm See page 26
METERING RATE –
Motor Factor, Weight Error, Low Weight See page 26
PARAMETERS –
List of adjustable parameters. See Parameter for more information See page 27
PRINT OPTIONS –
Parameter printout or time interval printouts to USB drive See page 23
UPDATE FIRMWARE –
For updating MGF Firmware See page 32
UPDATE USB CHIP -
For updating MGF’s USB firmware See page 32
RATE ADJ RESET –
Used to reset the Rate Adjustment back to 1.0000 See page 33
VIEW/RESET TOTALS –
Resets material usage totals and cycle counter See page 34
RESTORE DEFAULTS –
Restores MGF factory defaults See page 34
SETTINGS
CHANGE PASSWORD –
Changing the MGF Password (default: 2222) See page 18
MODE –
Configuring to run CYCLE, CONTINUOUS or Extrusion Following mode See page 19
UNITS –
Display units as US (Pounds, ounces) METRIC (Kilograms, grams) See page 20
LANG –
Language: English, French, Italian, German, Polish, Czech, Spanish See page 20
SET DATE AND TIME –
Date format (USA, Europe) and RTC setup See page 21
VOLUMETRIC -
Causes the MGF to run at a fixed rate based on current values. See page 22
AUTO STOP –
Used for extrusion and continuous. Turning on requires a See page 22
constant contact closure to run. Used normally to run and stop the MGF Feeder
automatically with the extruder. Only available with extrusion following models.