MAGSTIM NEUROSIGN V4, User Manual

Page: 41 / 86

The Magstim Company Ltd.
©
41
NOP08-EN-10
4.3 Adjusting The Screen Tilt
The angle of the screen may be adjusted by
loosening the screen tilt wheels on the either
side of the rear of the screen (right). Re-tighten
the wheels to secure your desired angle.
Ensure you have correctly connected the device and that the device is switched on
(see "4.2 Connection & Disconnection" on page 38).
Once the system is fully initialized the home screen (below) will be displayed.
Figure 4.1. Home screen
In subsequent uses, the option is given to restore the last session (below), with a
description of the profile and procedure used.
Figure 4.2. Restore last session
Selecting this will re-load the same procedural setup used before the nerve monitor
was switched off. If this was a personalised procedural setup, the surgeon profile
password will be required. This is only available if the connected pre-amplifier can
support the last procedure performed.
Note: The 'restore last session' function will restore the procedural setup only and not
the patient details, report or event logs. A new patient report must be created with
each use.
Screen
Tilt Wheel
4.4 Home Screen