Swing Door
MPS-122
Transport, mounting and installation
31
3. Loosen the 4 countersunk screws M8 and remove them.
Fig. 11: Remove countersunk screws
4. Pull out outer tube and remove it.
5. Loosen screws and remove cover.
Fig. 12: Left: Outer tube, right: Cover
6. Setting bores. You have the following options for this:
Place edge profile at the intended site so that the section in
the housing as indicated in Fig. 12 is about central in the
direction of the desired home position. Mark bores. Put
edge profile aside. Setting bores.
The home position is the resting position of the locking
element.
Place the bores according to the drilling plan.
→
See page 27, Fig. 6 and page 28, Fig. 7.
7. Carefully remove any sand and swarf from the bore holes and
their immediate vicinity.
8. Set the anchor rods with the glue cartridges and let them cure
according to the enclosed description. Observe curing time of
the cartridges.
