Magnetic Autocontrol MHTM MicroDrive, Operating Instructions Manual

Page: 75 / 196

Barrier MHTM
TM
MicroDrive
Assembly and installation
5815,5001US / Version 02.66 75
13. Push the barrier into the top-most position. The clamping lever
must be at the stop for the "open" position. If required, push
straight through the upper tool bore with a tool to press the
lever arm from the dead point.

See page 168, chapter 13.5.
14. Check the vertical alignment of the barrier arm with a level
and correct with the hexagon socket screws at the flange if
necessary.
15. Switch on power supply.
16. Switch the "Service" switch on the control unit. The LED lights
red. The display backlighting flashes.

See page 122, chapter 10.7.7 Mode "Service".
17. Close the control unit with the middle right button at the
control unit.
18. Check the horizontal alignment of the barrier arm with a level
and correct with the hexagon socket screws at the flange if
necessary.
19. Switch the "Service" switch on the control unit. The LED must
light green.
20. Switch off power supply.
21. Install the barrier housing door.
22. Attach and lock the barrier housing hood.
8.11.2 Barrier arm type "MicroBoom-T"
1. Secure barrier danger area e.g. with barrier tape.
2. Remove the barrier housing hood.
3. Remove the barrier housing door.
WARNING!
Danger of crushing between barrier arm and barrier housing!
4. Switch off power supply. Ensure that the system is powered
down. Secure against reactivation. The balancing springs in
the lever system are relaxed (boom raised).