Magnetic Autocontrol MHTM MicroDrive, Operating Instructions Manual

Page: 127 / 196

Barrier MHTM
TM
MicroDrive
Parameterising control unit
5815,5001US / Version 02.66 127
10.10.6 Vend count
Operating view

Main menu

Setup

Vend count
Parameters Description
Reset behaviour Use this parameter to set vend count reset behaviour. The function "Vend
count" is available for program modes 4 to 8. An internal vend count counts the
pulses present at the input with the "Opening with vend count" function.
The pulses are decremented only in driving direction 1 "Safety loop

Opening
loop".
Options
 No counter reset (without vend count reset)

Time-out
The vend count is set to the value "0" if the vehicle does not pass the
supervision device within the set hold-open time.
 Reset on closing
The vend count is set to value "0" when a closing signal is given.
 Time-out/Reset on closing
The vend count is set to the value "0" if the event "Time-out" or the event
"Reset on closing" occurs.
Factory setting
 Time-out/Reset on closing
Counter This parameter shows the current counter reading of the vend count.
Table 45: Menu "Vend count"
Example vend count
with program mode
"Automatic mode (5)" This mode is suitable for the automatic operation of a barrier, e.g.
with card readers, remote control, coin accepters and induction
loops or light barriers. The control units and the barrier have a
larger distance from each other. Instead of a hold-open time, an
internal vend count is incremented and decremented. Passage of
the barrier is possible in either direction.