Magnetic Autocontrol MHTM MicroDrive Access Series, Operating Instructions Manual

Page: 84 / 144

Barrier MHTM
TM
MicroDrive Access and Parking
Electrical connection
84 5815,5013US / Version 05
Electric voltage
DANGER
Mortal danger by electric voltage!
Touching live parts can be lethal.
Damage to the insulation or to individual compo-
nents can be lethal.
– Switch off the power supply immediately in case
of damage to the insulation and arrange repair.
– Only electrical specialists may carry out work on
the electrical system.
– Switch off power supply and secure against
reactivation before performing any work. Test
for absence of voltage!
– Never bypass or deactivate fuses.
– When replacing fuses observe the correct
amperage specification.
– Keep moisture and dust away from live parts.
Moisture or dust may cause a short circuit. If the
electrical connection is established during
precipitation, e.g. rain or snow, penetration of
moisture must be prevented by suitable
measures, such as a protective cover.
General WARNING
Danger by inappropriate installation!
Inappropriate installation can result in severe and
lethal injuries.
– Only electrical specialists must perform any
electrical installation tasks.
– Pay attention to tidiness and cleanness at the
assembly site! Loosely stacked or lying around
components and tools are accident sources.
– Tighten all screws correctly.
Hot surfaces CAUTION
Danger of burns!
The motor surface may be hot. Touching this hot
surface can lead to burns.
– Do not touch these hot surfaces.
– After switching off the power supply wait some
minutes until the motor has cooled down.
– Wear protective gloves if necessary.