Magnetic Autocontrol MHTM MicroDrive Access Series, Operating Instructions Manual

Page: 114 / 144

Barrier MHTM
TM
MicroDrive Access and Parking
Malfunctions
114 5815,5013US / Version 05
Number Description Possible cause Corrective action
6000
ERROR Module update
error
A firmware update was not
performed correctly.

Restart the control unit

If the error continues to be
present, perform the update
again via the service
module.
6102
ERROR Software error
system bus
Within the control, an error is
pending in communication.

Check FW versions of all
plug-in modules. If required,
perform update via service
module.

If all FW versions are up to
date, contact service.
6105
ERROR Error during
homing
The barrier could not perform
any reference run.

Check motor
communication.

Check mechanics.

Perform reset. → See
page 118, chapter 12.4.
8130
WARNING Note monitoring Communication with a plug
module was interrupted.

Check if all plugged
modules are listed in the
main menu.

Perform reset. → See
page 118, chapter 12.4.

Contact service if required.
Table 24: Event, warning and error messages – logic control (control unit)
12.3.2 Event, warning and error messages – Motor GW
Number Description Possible cause Corrective action
2220
WARNING Overcurrent Overcurrent was recognised

Warning may appear in
connection with impact.

If no impact took place,
check the cables.

Contact service if required.
3211
WARNING Overvoltage Overvoltage was recognised

Warning may appear in
connection with impact.

If no impact took place,
check the cables.

Contact service if required.