Magnescale MG10-P1, Instruction Manual

Page: 57 / 132

(E)
9
MG10-P1 / MG10-P2
3-3. Installing the Unit on the DIN Rails
When the multi interface unit is shipped from the factory, the tabs
on the DIN rail anchoring levers are locked.
DIN rail specifications: 35 mm
1
Align the top side of the groove in the unit’s rear panel with
the top of the DIN rails.
2
Install the unit by pushing it into position until a clicking sound
is heard so that the bottom side of the groove in the unit’s rear
panel fits snugly on the DIN rails.
Check that the whole unit has been installed properly.
<When removing the unit from the DIN rails>
While holding the unit in place so that it will not fall, pull down the
DIN rail anchoring levers of all the modules until a clicking sound
is heard.