Magnescale MG10-P1, Instruction Manual

Page: 68 / 132

20
(E)
MG10-P1 / MG10-P2
5-3. Settings of Counter Modules Sold
Separately
For the counter module, the module address and the count polarity
and resolution of the measuring unit to be connected are set by
using switches.
For further details, refer to the operating instructions of the counter
module.
5-3-1. Counter Module Number (Channel
Number) Setting Switch
This switch is used to set the module number to a number from 0 to
F.
Module numbers are used to designate the channel number of the
measuring unit in the commands which are input for the settings
and operations.
Do not use the same number for more than one module in the same
unit.
Setting the same number for more than one module will prevent
the system from operating properly.
5-3-2. Measuring Unit Settings
Set the measuring unit setting switches to suit the measuring unit
to be connected.
For further details, refer to the operating instructions of the counter
module concerned.
Count polarity setting SW 1
Push-in direction “
+
” ON
Push-in direction “
−
” OFF
Bold print is used to indicate the factory settings.
Sensor supported SW 2 SW 3 SW 4 Resolution
— OFF OFF OFF Not used
DK series (0.1
µ
m) ON OFF OFF 0.1
µ
m
DK series (0.5
µ
m) OFF ON OFF 0.5
µ
m
DG
∗∗
B series
DT512 ON ON OFF 1
µ
m
DT12, DT32, OFF OFF ON 5
µ
m
DL
∗∗
BR
DL310B, DL330B ON OFF ON 10
µ
m
— OFF ON ON Not used
— ON ON ON Not used