Maggi STEFF 2034, Manual

Page: 44 / 339

EN
43
All adjustments must be made
while the machine is disconnected
from the mains by unplugging.
3-1 HEIGHT ADJUSTMENT
To adjust the power feeder for height,
it is necessary to take account of the
thickness of the piece to be cut (see
Fig.12). Place the wheels at a height
approximately 3-5 mm less than the
height of feeding plane, so that they
hold firmly at all times; the suspension
system will offset any height
differences.
3-2 INCLINATION ADJUSTMENT
The power feeder has been designed
to be used on several machines. In
any case, to make sure that the piece
movement is parallel to the guide-
square, it is necessary to place the
power feeder at a slight angle to the
direction of the piece motion (see
Fig.13).
For applications in which the feeder is
used in “
vertical position”
, therefore,
make sure the distance (B) between
the outlet roll and the square is 5-6
mm less than that of the inlet roll (A).
For applications in which the power
feeder is used
in “
horizontal
position”
(Fig.14), make sure the
distance (B) between the outlet roll
and the plane of the machine is 5-6
mm less than the distance (A), which
is the distance between the inlet roll
and the plane of the machine tool.
CHAPTER 3 - USE AND ADJUSTMENTS
WARNING
Fig.12
Fig.13
A = B +5/6 mm
A = B +5/6 mm
Fig.14