51
English
Note that the content of the
Site ID
field is incremented by
1 after ending static occupation on a point (increment: 0
to 9, then A to Z, then 0.. again, etc.). You can however
change the
Site ID
between any two occupation times by
pressing the LOG key (not the on-screen
Log
button) and
editing the
Site ID
field.
13.Move to the next point and resume the above two steps
until all the points have been visited.
14.Tap
Done
after surveying the last point. This completes
the data collection phase.
Running a Kinematic Survey
This chapter describes a typical Kinematic survey in which
initialization is performed on a known point (The fastest ini-
tialization method.)
Base Setup and Operation
The base is setup and operated in the same way as it is in stat-
ic surveys (see
).
Rover Setup
Install the unit on its range pole:
1. Mount the GNSS antenna on the pole
2. Attach the field bracket onto the pole
3. Place the ProMark3 receiver into the field
bracket
4. Connect the GNSS antenna to the unit
using the cable provided.
5. Measure the antenna height.
Crosses indicate where
static occupations take
place.
0001
0002
0003
0004
0005
0006
0007
Rover
1.
4.
3.
2.
