MAESTRO WIRELESS SOLUTIONS
| Services
213
E SERIES | USER MANUAL VERSION 2.2.0
http://support.maestro-wireless.com
OpenVPN
12.1.5
Services > VPN > OpenVPN
Open VPN is an open-source software application that implements virtual
private network (VPN) techniques for creating secure point-to-point or
site-to-site
connections.
It
uses
the Open
SSL library
to
provide encryption of both the data and control channels. Open VPN can
run over User Datagram Protocol (UDP) or Transmission Control
Protocol (TCP) transports, multiplexing created SSL tunnels on a single
TCP/UDP port. Open VPN fully supports IPv6 as protocol of the virtual
network inside a tunnel and the Open VPN applications can also establish
connections via IPv6. It has the ability to work through most proxy
servers (including HTTP) and is good at working through Network
address translation (NAT) and getting out through firewalls. The server
configuration has the ability to "push" certain network configuration
options to the clients. These include IP addresses, routing commands,
and a few connection options.
E220 series supports Open VPN client, Server and Pass Through.
A.
Open VPN Client
You can access the Open VPN client in Services / Open VPN.
Open VPN Client will attach itself to the configured Open VPN server over
any available WAN interface. If the auto-connect function is enables,
Open VPN will not only connect over available WAN but also switch
between WANs as and when one WAN fails-over to another and also auto
starts in every reboot. This can be achieved by clicking on the enabled
tick box.
You can either edit the sample client or create your own configuration
from ground up.
Note
Only OpenVPN client is supported.
You must manually enter the DNS from
Network > DHCP and
DNS
.
