N
L
AgoraLED IP42
GB
AgoraLED
Test
Test
LAMP FAULT
BATT FAULT
POWER
CHARGE
EMERGENCY
LIGHTING
AGORALED
302mm
94mm
330mm
210mm
234mm
AgoraLED IP42
AgoraLED IP65
Test
Test
LAMP FAULT
BATT FAULT
POWER
CHARGE
EMERGENCY
LIGHTING
AGORALED
307mm
100mm
333mm
210mm
234mm
Dimensional Drawings:
Honeywell Life Safety AS, Po. Box 3514, N-3007 Drammen, Norway
http://www.hls-nordic.com
Installation:
(Wall Mounting Only)
2
Cover
retaining
screws
Mounting Holes
Test
Test
LAMP FAULT
BATT FAULT
POWER
CHARGE
EMERGENCY
LIGHTING
AGORALED
3
4
5
Step 1:
Hold the device on the wall and mark the holes with a marker. The distance between the mounting holes is
234mm. Drill the holes. Use the supplied mounting accessories to mount the device. Remove the four cover
retaining screws.
Step 2:
Install the cable grommet and pass the round cable. Connect the cables to the respective positions in the
terminal block L for phase and N for neutral.
Always use in any case round mains cable, with external diameter
2
of 6-9mm (H05RN-F type 2x1mm or any other type, at least equal to it’s mechanical and electrical
properties). ATTENTION!! The cable must not be deformed In any way.
Step 3:
Install the battery cable connectors to the batteries taking care of the polarity, black cable (-) and red cable (+).
Step 4:
In case you use a module connect it on the PCB.
Step 5:
The user can select one of the 3 available minimum durations: 1 hour, 3 hours and 8 hours. The selection must
be done while the luminaire is disconnected from AC and battery supplies. The selection is achieved through
Switches 2 & 3 of DS1. Switch 1 and 4 are not used. Two additional labels are included in the package, one for 3
hours duration (180) and one for 8 hours duration (480). Depending on the selected duration, the installer must
replace the default 1 hour (60) label with one that has the required duration.
Please take notice of the
orientation of the label.
Step 6:
There is a terminal block for connection to the (optional) communication modules (elBus, DALI and pot. free), in
the lower left corner of the PCB. The terminals are marked C1 and C2.
Step 7
: Make a hole in the right side of the luminaire, install the rubber gasket and make a hole in the center by using a
small screwdriver. Pass the round cables through the gasket and connect it on the terminals.
Step 8:
Close the front cover and fasten it with the removed screws. (Tightening torque 1 N*m)
6
C1C2
AgoraLED IP65
N
L
2
6
7
ON
1 2 3 4
ON
1 2 3 4
ON
1 2 3 4
1h
(default position)
3h
8h
Dip Switch Positions
1
