MAESTRO WIRELESS SOLUTIONS
| Network
177
E SERIES | USER MANUAL VERSION 2.2.0
http://support.maestro-wireless.com
Parameters
Description
Static IPv4 Routes
Name
Enter the name of the zone.
Input
Select to accept or reject the inbound traffic
to all the configured zones.
Output
Select to accept or reject the outbound
traffic from all the configured zones.
Forward
Select to accept or reject the forwarded
traffic from all the configured zones.
Masquerading
Check to allow IP Masquerading.
MSS clamping
Check to allow MSS clamping.
Covered
network
Select the network interfaces that must be
included in the zone configuration.
Inter-Zone Forwarding
Allow forward to
destination
zones
Select to allow or deny forwarding traffic to
the configured destination zone.
Allowed forward
from
source
zones
Select to allow or deny forwarding traffic
from the configured source zone.
Table 11.9-2: General Configuration for Firewall Zone (LAN)
Concept of zone based Firewall
A zone section groups one or more
interfaces
and serves as
s
ource
or
destination
for
forwardings
,
rules
and
redirects
. Masquerading (NAT) of
outgoing traffic is controlled on a per-zone basis. Note that masquerading is
defined on the
outgoing
interface.
INPUT rules for a zone describe what happens to traffic trying to reach the
router itself through an interface in that zone.
OUTPUT rules for a zone describe what happens to traffic originating from
the router itself going through an interface in that zone.
FORWARD rules for a zone describe what happens to traffic passing
between different interfaces in that zone.
By default, there are 2 zones which are already created in the Router, Viz LAN
Zone and WAN Zone. All traffic from LAN to WAN has no restrictions but all
incoming traffic on WAN side is blocked unless a port forwarding rule is set or
unless a particular port is opened.
