Macrovision Corporation M350C MILANO, User Manual, Page: 73 / 176

Advanced Controls
Display Devices 3 - 9
3
Display Devices
Besides the built-in LCD, you can also use an external VGA monitor (CRT)
or TV as your display device. A VGA monitor connects to the external mon-
itor (CRT) port
,
a TV to the S-Video Out port ( Figure 3 - 5 ).
Switching/Enabling Displays (Keyboard)
You can switch display devices with the Fn + Display (F6) toggle. With the
video driver installed , you also can use its built-in controls to switch the dis-
play options. If you haven’t installed the video driver, refer to (see “What to
Install” on page 4 - 2 ) for setup instructions. To switch the display options:
1. Plug the VGA monitor or TV into the appropriate port.
2. Press and hold the Fn key, while simultaneously pressing the F6 key.
Note : If you are using a TV use the hot key combinations Ctrl + Alt + F1 (CRT
only), Ctrl + Alt + F2 (TV only) and Ctrl + Alt + F3 (LCD only), not Fn + F6 .
3. You may toggle through the options to display the LCD only, the external
display alone and the LCD and the external display together (make sure you
allow time for the screens to refresh as you toggle through).
Using the Driver to
Switch Displays
If you only use the key-
board toggle to switch
through the display op-
tions you will not have
all the configuration
options available to
you. If you want to ac-
cess the options listed
in
“Display Devices”
on page 3 - 9 use the
driver control panel to
configure the settings
as per
“Switching/En-
abling Displays (Driv-
er)” on page 3 - 10
.
Figure 3 - 5
Left Side View
1 2
1 2