Macrovision Corporation M350C MILANO, User Manual, Page: 126 / 176

Upgrading The Computer
6 - 8 Upgrading the System Memory (RAM)
6
3. Gently pull the two release latches ( & in
Figure 6 - 6 )
on the sides
of the memory socket toward the sides of the computer.
4. The module will pop-up, and you can remove it.
5. Pull the latches to release the second module if necessary.
6. Insert a new module holding it at about a 30° angle and fit the connectors
firmly into the memory slot.
7. The module’s pin alignment will allow it to only fit one way. Make sure the
module is seated as far into the slot as it will go. DO NOT FORCE the
module; it should fit without much pressure.
8. Press the module in and down towards the mainboard until the slot levers
click into place to secure the module.
9. Replace the memory socket cover and the 4 screws (see Figure 6 - 5 ).
10. Restart the computer.
11. The BIOS will register the new memory configuration as it starts up.
1 2
2
3
1
3
Contact Warning
Be careful not to touch
the metal pins on the
module’s connecting
edge. Even the clean-
est hands have oils
which can attract parti-
cles, and degrade the
module’s perfor-
mance.
Figure 6 - 6
Removing/
Installing a RAM
Module
3