MacDon M1170, Operator'S Manual

Page: 90 / 528

214733
74
Revision A
Auger Header
•
On an A40DX auger header, the reel and auger speeds are hydraulically linked. When the reel speed is changed, the
auger speed changes automatically.
IMPORTANT:
Reel speed on auger header MUST NOT EXCEED 85 rpm. Auger speed MUST NOT EXCEED 320 rpm.
One-Touch-Return Buttons (A, B, C)
One-Touch-Return buttons save header configuration settings and serve as presets for quickly returning the header to
specific settings.
1013381
Figure 3.62: One-Touch-Return Buttons on GSL
The One-Touch-Return buttons A, B, and C always save header
height settings, but the following settings can also be saved
depending on the header type:
•
Header tilt
•
Deck position/header float selection
•
Double windrow attachment (DWA) or swath compressor
raise/lower
•
DWA speed
•
Knife speed
•
Draper speed
•
Reel speed
•
Reel height
•
Reel fore-aft
•
Disc speed
To program the One-Touch-Return buttons, press and hold button A, B, or C on the GSL handle for 3 seconds until an
audible tone is heard, indicating the current header settings are saved to that button.
To return header to a preset condition, tap the A, B, or C button quickly. Holding the One-Touch-Return button too long
can inadvertently reprogram the current header settings.
OPERATOR
’
S STATION