MacDon DWA, Operation And Parts Manual

Page: 54 / 98

MAINTENANCE AND SERVICING
To remove the drive roller from the deck, follow these steps:
1. Raise deck, and engage safety pin (A).
2. Remove front skid, loosen and remove draper. Refer
to
4.1.5 Adjusting Front Skid, page 44 .
Figure 4.9: Safety Pin
3. Loosen the two jam nuts (A) and two set screws (B).
NOTE:
The second jam nut and set screw are on
the opposite side and are not visible in this
illustration.
Figure 4.10: Draper Drive Roller
4. Remove the drive roller (A) by removing bolt and
washer (B) at end of the roller.
5. Slide the drive roller off the motor shaft.
6. If you need to repair the bearing or seal, refer to 4.1.8
Replacing Draper Roller Bearing/Seal, page 48 .
Figure 4.11: Draper Drive Roller
214048
46
Revision A