MacDon DWA, Operation And Parts Manual

Page: 25 / 98

ASSEMBLY/SETUP INSTRUCTIONS
15. Adjust the turnbuckle length so the space (A) between
the deck and the right-hand drive tire is approximately
100 mm (4 in.).
NOTE:
The single-acting lift cylinder is pressurized with
the draper drive circuit. Therefore, when the
deck is set up for the rotary disc headers, the
windrower needs to be running for the deck to
be in its most forward position. This adjustment
can be fine-tuned when the hydraulics setup is
complete.
Figure 2.17: Deck and Right-Hand Drive Wheel
16. Raise backsheet (A) on the deck and remove the top
nut (B) and tapered nut (C).
Figure 2.18: Backsheet
17. Install the gas shock (D) onto the bolt on the backsheet.
Install tapered nut (C) and torque the nut to 24–27 N·m
(218–241 in·lbf). Install nut (B) and torque the nut to
24–27 N·m (218–241 in·lbf).
IMPORTANT:
Make sure the taper of nut (C) is facing the gas
shock rod end as shown.
Figure 2.19: Gas Shock
214048
17
Revision A