MacDon DWA, Operation And Parts Manual

Page: 24 / 98

ASSEMBLY/SETUP INSTRUCTIONS
9. Position the deck pivot (A) into the linkage clevis (B).
NOTE:
Make sure there is a loose bushing inside the
deck pivot (A).
10. Align the deck pivot (A) with the holes in the clevis (B)
by raising or lowering the floor jack, and insert shaft (C)
with preinstalled hex nut (D) and lock nut (E) through
the top.
11. Install a regular hex nut (D) to the bottom of the deck
pivot shaft and torque the nut to 339 N·m (250 ft·lbf).
12. Install a lock nut (E), and tighten against nut (D).
IMPORTANT:
Apply proper torque to nuts.
13. Add grease to grease zerk (F).
Figure 2.15: Deck Pivot and Linkage Clevis
14. Attach turnbuckle (A) from linkage to deck.
• If used with an R-Series Rotary Disc Header, use
the inner pivot (B)
• If used with an A-Series Auger, use the outer
pivot (C)
NOTE:
The turnbuckle length should be approximately:
• 530 mm (21 in.) long for a R-Series Rotary
Disc Header
• 630 mm (25 in.) long for a A-Series
Auger Header
Figure 2.16: Adjustable Turnbuckle
214048
16
Revision A