MacDon DWA, Operation And Parts Manual

Page: 20 / 98

ASSEMBLY/SETUP INSTRUCTIONS
2.2 Installing the Linkage
To install the linkage on a M1240 windrower, follow
these steps:
1. Remove four bolts (A), two washers (B) and two
nuts (C) that are loosely installed on the DWA linkage.
Keep hardware for mounting.
Figure 2.3: Linkage Support
2. Support linkage assembly (A) with a forklift (B) and lift
into place under windrower.
NOTE:
Approach the windrower with the forklift from the
right-hand cab-forward side. With the stairs lifted
this will be the easiest to access. Make sure the
forks do not lift against the cylinder fitting.
Figure 2.4: DWA Linkage
3. Line-up DWA linkage with windrower connection
points.
Figure 2.5: Windrower Connection Points
214048
12
Revision A