CAUTION
Check to be sure all bystanders have cleared the area.
14. Start engine and press the HEADER UP switch (A) on
the GSL to raise header to maximum height.
15. Stop engine and remove the key from the ignition.
Figure 3.22: GSL
16. Engage safety prop on the windrower’s lift cylinder
as follows:
a.
Pull lever (A) and rotate toward header to release,
and lower safety prop onto cylinder.
b.
Repeat for opposite lift cylinder.
IMPORTANT:
Ensure the safety props engage over cylinder
piston rods. If safety prop does not engage
properly, raise header until prop fits over the rod.
Figure 3.23: Cylinder Safety Prop
17. Install the pin (B) through header leg (engaging
U-bracket in draper header support) on both sides and
secure with hairpin (A).
18. Raise header stand (D) to storage position by pulling
spring pin (C) and lifting stand into uppermost position.
Release spring pin (C).
Figure 3.24: Header Leg
214017
26
Revision A
