5.
Place 6 in. (150 mm) blocks (A) under each end and
center of cutterbar, and then lower header onto blocks.
6.
Remove chain and move lifting vehicle to rear
of header.
7.
Attach chain to center-link anchor on frame tube and
raise rear of header so that stand can be lowered.
Figure 2.10: Block at One End of Cutterbar
8.
Lower the header stand: pull pin (A), lower stand (B),
and release pin (A) to secure stand in place.
9.
If ground is soft, place a block under the stand.
10. Lower header onto stand.
11. Remove chain.
Figure 2.11: Header Stand
214017
12
Revision A
