8.
Drive the windrower slowly forward until the draper
header supports (A) enter the header legs (B).
Continue driving slowly forward until lift linkages
contact the support plates in the header legs and the
header nudges forward.
9.
Ensure that lift linkages are properly engaged in header
legs and are contacting the support plates.
Figure 3.19: Header Leg and Draper Header
Support
10. Press HEADER TILT UP (A) and HEADER TILT
DOWN (B) cylinder switches on the ground speed
lever (GSL) to extend or retract center-link cylinder until
the hook is aligned with the header attachment pin.
11. Stop engine and remove key from ignition.
Figure 3.20: GSL
12. Push down on rod end of link cylinder (B) until hook
engages and locks onto header pin.
IMPORTANT:
Hook release must be down to enable self-locking
mechanism. If the release is open (up), manually
push it down after hook engages header pin.
13. Check that center-link (A) is locked onto header by
pulling upward on rod end (B) of cylinder.
Figure 3.21: Hydraulic Center-Link
214017
25
Revision A
