Troubleshooting Guide (Cont.)
Problem
Possible Cause
Solutions
SALL LED’s on flight
controller flash
rapidly and aircraft
will not respond to
transmitter.
Transmitter too near aircraft
during binding process.
Power off the transmitter. Move
the transmitter a larger distance
from the aircraft. Disconnect and
reconnect the flight battery to the
aircraft. Follow the binding
instructions.
Bind switch or button was not held
while transmitter was powered on.
Power off transmitter and repeat
bind process.
Aircraft or transmitter is too close
to large metal object, wireless
source or another transmitter.
Move aircraft and transmitter to
another location and attempt
binding again.
Blue LED on the
receiver flashes
rapidly and the RV
Micro will not respond
to the transmitter
(after binding).
Less than a 5-second wait between
first powering on the transmitter and
connecting the flight battery to the RV
Micro.
Leave the transmitter powered
on. Disconnect and reconnect
the flight battery to the RV
Micro.
The RV Micro is bound to a
different transmitter.
Disconnect and reconnect the
flight battery to the RV Micro.
Power off transmitter and
repeat bind process.
Flight battery or transmitter battery
charge is too low.
Replace or recharge batteries.
Aircraft or transmitter is too close
to large metal object, wireless
source or another transmitter.
Move aircraft and transmitter to
another location and attempt
connecting again.
Crashes immediately
upon lift-off.
Propellers in wrong locations or
incorrect flight mode selected.
Check motor and propeller
orientation and make necessary
flight mode adjustments.
40
